Installing Plex Media Server on Debian Jessie

If you're looking to set up a media server on your network using Plex, you'll need to install Debian Jessie and configure it properly. In this guide, we will walk you through the process of installing Plex Media Server on Debian Jessie.

Step 1: Boot into Recovery Mode

To start, boot your device into recovery mode by pressing the SPACE key and the number '1' simultaneously during the boot process. This will bring up a MARVEL> prompt where you can manually configure your device.

Step 2: Manually Configure Your Device

Once in recovery mode, you may need to manually replace the uImage and uRamdisk files using the `dd` command. This can be done by TFTP-ing Debian Jessie onto your device.

Step 3: Rebuild SDB and Remove/Re-add HDDs

If one of your hard drives is malfunctioning, you'll need to rebuild it and remove and re-add it to the RAID array. This can be done by using the `dd` command and reconfiguring your RAID arrays.

Step 4: Install Debian Jessie

Once you have successfully booted into recovery mode and configured your device, you can install Debian Jessie onto your device. To do this, upload the Debian firmware file to your device and reboot it.

Step 5: Configure Plex Media Server

After installing Debian Jessie, you'll need to configure Plex Media Server. This can be done by following the instructions provided on the Plex website.

By following these steps, you should be able to successfully install Plex Media Server on your Debian Jessie device. Remember to take your time and carefully follow each step to ensure a smooth installation process.

Debian jessie install plex media server